|
|
Item Posts
Sort Order
|
|
|
87 REGAL TRANS SWAP
|
po_choppa
New User
| Posts: 22
| Joined: 07/08
Posted: 08/03/09
07:59 PM
|
|
LET ME GIVE THE CAR INFO FIRST. I HAVE A 87 BUICK REGAL WITH A FACTORY OLDS 307 AND 200R4 TRANS. THE TRANSMISSION WENT BAD, SO MY QUESTION IS, WILL A 700R4 BOLT UP TO THIS OLDS 307.
|
|
|
|
waynep712
Enthusiast
| Posts: 436
| Joined: 10/07
Posted: 08/03/09
10:03 PM
|
|
nope... 700r4 only came with chevy bolt pattern... and possibly as i remember.. a small V6 pattern.. but i am not sure..
i have only heard about them.. never seen one..
check out this link..
http://www.crankshaftcoalition.com/wiki/General_Motors_transmissions
there are shops out there that are building the 200R4 to take huge amounts of horsepower..
seems the input shaft is stronger.. only one hole drilled.. vs.. 3, side by side on the 700...
|
|
|
|
68scott385
Enthusiast
| Posts: 314
| Joined: 05/09
Posted: 08/03/09
11:22 PM
|
|
i don't know if the 700r4 was produced with a BOP bell housing pattern, but if it did, it's 3 inches longer than the 200/4r and has a different throttle valve set up
unless the 700r4 is real cheap a different or rebuilt 200/4r may be the easier, less complicated route
-
the red-headed step-child of the mailing list
fuzzy dice, air shocks & N50's rule
|
|
|
|
|
|
|
Posted: 08/04/09
10:07 AM
|
|
No the 700R4 will not bolt to the olds 307.
Professional hi-performance engine builder
Horsepower sells Engines and torque wins races.
|
|
|
|
po_choppa
New User
| Posts: 22
| Joined: 07/08
Posted: 08/04/09
02:50 PM
|
|
THANK YOU.
|
|
|
|
|
|
|